Safe healthcare linen handling comes down to a few habits: keep soiled and clean linen physically separate, bag soiled linen where it is used with as little shaking as possible, transport it in covered carts or closed bags, and store clean linen covered in a clean, dry area until use. Your laundry, whether in-house or outsourced, then washes it under controlled conditions and returns it without recontamination.
This guide summarizes widely accepted practice for hospitals and long-term care facilities. It is a general overview, not a policy. Requirements change and vary by state, so always check current CDC and state guidance and confirm procedures with your infection prevention team.
Why linen handling matters
The risk of disease transmission from properly handled and laundered healthcare linen is generally considered very low. Most of that risk is controlled by what happens before and after the wash: how soiled linen is collected, how it travels, and how clean linen is protected. Good handling also protects staff, reduces linen loss and extends the life of your textiles.
Keep soiled and clean linen separate
Separation is the foundation of every linen program. Soiled and clean linen should never share the same cart, shelf, room or route if you can avoid it.
- Separate spaces. Soiled utility rooms and clean linen rooms should be distinct. In laundries, soiled receiving and sorting areas are kept apart from clean processing and folding areas, often with airflow designed to move from clean toward soiled.
- Separate carts. Use dedicated, clearly labeled carts for soiled and clean linen, or a cart that is cleaned and disinfected before switching use according to your policy.
- Separate hands. Staff handling soiled linen wear the personal protective equipment your facility requires, then remove it and perform hand hygiene before touching clean linen.
Bagging soiled linen with minimal agitation
CDC guidance has long emphasized handling contaminated textiles with minimal agitation to avoid releasing microorganisms into the air and onto surfaces and people. In practice:
- Bag at the point of use. Place soiled linen directly into a bag or hamper in the patient room or care area. Do not carry loose linen down the hall.
- Do not shake. Roll or fold soiled linen inward, with the most soiled area in the center.
- Do not sort or rinse in patient-care areas. Sorting and pre-rinsing belong in the laundry, not at the bedside.
- Remove solid waste first per your facility's procedure, without spraying or splashing.
- Use leak-resistant bags for wet linen so fluid does not soak through during transport.
- Do not overfill. Close and tie bags securely, typically when they are about two-thirds to three-quarters full, so they do not burst or need re-handling.
- Follow your labeling policy. OSHA's Bloodborne Pathogens Standard addresses bagging, labeling or color coding of contaminated laundry. Many facilities treat all soiled linen as potentially contaminated; confirm what your policy and your laundry require.
Rule of thumb: If a staff member has to reach into a soiled linen bag for any reason, the bagging step has failed. Train for "roll, bag, tie, never reopen."
Transporting linen
Linen often travels through public corridors and elevators, so transport is where separation is easiest to lose.
- Use covered or enclosed carts for both soiled and clean linen, and keep the covers closed.
- Where possible, schedule soiled linen pickups and clean linen deliveries at different times or on different routes.
- Clean and disinfect carts on a set schedule, and immediately after any leak or spill.
- If linen chutes are used, keep bags closed and follow the chute's design and maintenance requirements.
- For outsourced laundry, make sure clean linen arrives wrapped or in covered carts, and that the vehicle keeps soiled and clean loads separated.
Laundering: what the guidance covers, in general
The CDC's environmental infection control guidelines describe laundering as a combination of mechanical action, water temperature, detergents and other chemicals, followed by drying and, in many operations, ironing. Historically, hot-water washing at around 160°F (71°C) for about 25 minutes has been cited, and lower-temperature washing has also been described as acceptable when appropriate chemicals and dosing are used. The exact cycle depends on your equipment, chemistry and the soil type.
Because these details are technical and periodically updated, rely on your laundry manager, your chemical supplier and your infection prevention team to set and validate wash formulas. Your linen supplier can tell you which constructions tolerate those formulas best; see our hospital linen guide for how blend and construction affect durability.
Storing clean linen
Clean linen can be recontaminated by dust, moisture, hands and proximity to soiled items. Protect it from the moment it leaves the laundry.
- Clean linen room or closet is used only for clean supplies
- Linen stored covered, on shelves or carts off the floor
- Bottom shelf solid or raised enough to avoid floor splash during cleaning
- No storage under sinks or near plumbing leaks or sources of moisture
- Door kept closed; cart covers kept down
- Stock rotated first in, first out
- Linen that touches the floor or a soiled surface sent back to the laundry
- Only the amount needed taken into patient rooms; unused linen from isolation rooms handled per policy
Working with an in-house vs outsourced laundry
Both models can work well. The right one depends on your volume, space, capital and staffing.
| Consideration | In-house laundry | Outsourced laundry |
|---|---|---|
| Control | Direct control of formulas, turnaround and priorities | Controlled by contract and service levels |
| Capital and space | Requires equipment, space, utilities and maintenance | Little or no on-site equipment |
| Staffing | You hire, train and manage laundry staff | Provider staffs the plant |
| Linen ownership | Usually owned by the facility | Owned by the facility (customer-owned goods) or rented from the provider |
| Turnaround | Can be same day | Depends on pickup and delivery schedule, often 24 to 48 hours |
| Key risk | Equipment downtime and staffing gaps | Missed deliveries, loss in transit, less visibility |
Questions to ask an outsourced laundry
- How are soiled and clean areas separated in the plant and in delivery vehicles?
- How are wash formulas set and checked, and can you share them with our infection prevention team?
- Do you hold any accreditation for healthcare laundry, and can we see documentation?
- How is clean linen packaged for delivery?
- How do you track and report loss, rejects and stains by customer?
- What is the backup plan if the plant goes down?
Whatever the model, set par levels with turnaround in mind. A longer laundry cycle needs more linen in circulation. Our par level guide explains the math.
What to ask your linen supplier
Your laundry protects patients; your linen supplier determines how well your textiles survive the process. Ask:
- What is the blend and construction? Fiber content, thread count or weight, hem and seam style.
- What wash conditions has this item been used in? Ask whether it has been used in healthcare laundries with high temperatures and bleach.
- What shrinkage should we expect? Sizes that shrink too much fit beds poorly and are retired early.
- Is color coding colorfast? Stripes and colors should survive your chemistry.
- Can we test samples first? Run a small batch through your own laundry before switching.
- What are lead times, and is stock held close by? Fast replenishment lets you carry less safety stock.
- What is in writing? Do not accept certification or compliance claims without documentation.
CATELS supplies durable sheets, color-coded items, underpads and waterproof pillows and covers for hospitals and long-term care, with 24 to 72 hour delivery in California and Baja California. Visit our healthcare page to see what we carry.
Quick reference: linen handling do's and don'ts
| Do | Don't |
|---|---|
| Bag soiled linen at the point of use | Carry loose soiled linen through halls |
| Roll soiled linen inward gently | Shake or fling linen |
| Use leak-resistant bags for wet linen | Overfill bags or reopen them |
| Use covered, dedicated carts | Mix clean and soiled on one cart |
| Store clean linen covered and off the floor | Store linen under sinks or in soiled rooms |
| Perform hand hygiene before touching clean linen | Handle clean linen with used gloves |
Use this as a training starting point, then align every step with your facility's written policy and current guidance.
Frequently asked questions
How should soiled linen be handled in a hospital?
Bag soiled linen at the point of use with minimal agitation, rolling it inward rather than shaking it, and use leak-resistant bags for wet items. Do not sort or rinse it in patient-care areas, and follow your facility's current policy and CDC and state guidance.
How should clean linen be stored in healthcare facilities?
Store clean linen covered, off the floor, in a dedicated clean area away from moisture and soiled items. Rotate stock and send back any linen that touches the floor or a soiled surface.
What temperature should hospital linen be washed at?
CDC guidance has historically cited hot-water washing around 160°F (71°C) for about 25 minutes, and also describes lower-temperature washing with appropriate chemicals as acceptable. Your laundry and infection prevention team should set and validate the actual formulas using current guidance.
Should a hospital use an in-house or outsourced laundry?
It depends on volume, space, capital and staffing. In-house laundries give more control and faster turnaround, while outsourced laundries avoid equipment and staffing costs but depend on contracts and delivery schedules.